Normal Mechanisms of Haemostatic Control

Revision as of 16:18, 15 October 2013 by Bara (talk | contribs)

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)

Introduction

Haemostasis is the normal spontaneous arrest of bleeding from ruptured blood vessels. Normal haemostasis depends on a combination of events: the vascular response, which occurs mainly at capillary and small blood vessel level, the platelet (or thrombocyte) response, which also occurs in capillaries and small vessels, and the blood coagulation response which takes place in the arteries and veins.

Heamostasis is also conventionally classified into:

  • Primary haemostasis involves platelets and the blood vessels themselves and is triggered by injury to a vessel - platelets become activated, adhere to endothelial connective tissue and aggregate with other platelets. A fragile plug is formed which helps to stem haemorrhage from the vessel. Substances released from platelets during primary haemostasis include vasoactive compounds to induce vasoconstriction and other mediators that cause continued platelet activation and aggregation, as well as contraction of the platelet plug. Primary haemostasis ceases once defects in the vessels are sealed and bleeding stops.
  • Secondary haemostasis occurs when proteinaceous clotting factors interact in a cascade to produce fibrin to reinforce the clot. Two arms of the cascade are activated simultaneously to achieve coagulation: the intrinsic and extrinsic pathways. The intrinsic pathway is activated by contact with collagen due to vessel injury and involves the clotting factors XII, XI, IX and VIII. The extrinsic pathway is triggered by tissue injury and is effected via factor VII. These pathways progress independently before converging at the common pathway, which involves the factors X, V, II and I and ultimately results in the formation of fibrin from fibrinogen. Factors II, VII, IX and X are dependent upon vitamin K to become active.
  • Fibrinolysis is the final stage of restoring haemostasis - it prevents uncontrolled, widespread clot formation and breaks down the fibrin within blood clots. The two most important anticoagulants involved in fibrinolysis are antithrombin III (ATIII) and Protein C. The end products of fibinolysis are fibrin degratation products (FDPs).

Vascular Responses

There are several possible vascular responses, of which one or more may be recruited in normal haemostasis.

  1. Vascular contraction: This is usually a temporary process which gives a partial arrest of blood flow. It is an important mechanism in larger vessels.
  2. Vascular shunting: Blood is redistributed using alternative pathways to by-pass the injured area.
  3. Increased blood viscosity: This is also known as the "sludging" effect; the RBCs become more densely packed due to plasma loss through vascular walls and leaky plugs.
  4. Plasma loss: Loss of plasma to the surrounding tissue spaces results in pressure on the vessel walls.

Coagulation physiology

Coagulation Cascade Source: Wikimedia Commons. Author: Joe D (2007)

The process of blood coagulation is a cascade system involving a series of conversions of proenzymes to active forms. The amount and speed of conversion increases at each level. The major trigger for the system is contact activation.

There are both intrinsic and extrinsic systems within the clotting cascade.

The Intrinsic System

This refers to clotting factors which are derived from plasma. The intrinsic system can operate in the absence of tissue damage. It takes some minutes for the body to activate the intrinsic system.

The Extrinsic System

This refers to tissue thromboplastin and depends on vascular damage as a trigger. It involves platelet activity and operates in a matter of seconds.

The plasma and tissue (intrinsic and extrinsic) components combine to produce thrombin which releases ADP from platelets in order to recruit more platelets to the plug.

Platelet Responses

Platelet responses are critical in maintaining haemostasis. When platelets are activated, the haemostatic plug is formed. Regulation by the contractile platelet protein thrombosthenin gives clot organisation and fibrin formation; the clot continues to organise and contract over the 3-5 days following formation. Thrombosthenin is present in platelet granules and in the platelet membrane.

A series of events activates platelets to allow them to form the haemostatic plug:

Adhesion

The first stage in platelet activation is an increase in the adhesiveness of platelets which may be initiated by several scenarios:

  • The release of ADP from damaged endothelial cells.
  • Platelet contact with collagen or basement membrane.
  • Platelet contact with some denatured proteins and antibody-antigen complexes.

A friable and leaking plug is formed within 1 minute by this adhesion stage.

Agglutination

More ADP is released, bringing and linking more platelets into the clot.

Aggregation

This is also known as viscous metamorphosis - platelets aggregate to form a tightly packed mosaic which results in compaction of the plug. This gives a good temporary seal to the injured vessel in about 5-30 minutes.

Disruption

Further aggregation of platelets is stimulated by prostaglandin endoperoxide (PGG2) release. Platelet breakdown produces phospholipids (platelet factors 3 and 4).

Platelet factors catalyse the conversion of soluble fibrinogen to insoluble fibrin resulting in a progessive infiltration of the initial thrombocyte plug by strands of fibrin, leading to the formation of a composite plug. The fibrin also polymerises, causing coagulation of the blood and clot formation.

After the clot has formed, the platelets actively contract; the contractile protein is thrombosthenin. The fibrin strands shorten, increasing the strength of the clot and bringing the blood vessel walls closer together. The clot is progressively broken down by fibrinolysis and infiltration by new fibroblasts and capillaries occurs. Granulation tissue is formed within 3 days, and permanent repair, either functional or non-functional, occurs in around 1 week.

Regulation of Coagulation

The blood coagulation process is beneficial, as it is designed to minimise blood loss, however, if the mechanism is prematurely or inadvertently triggered or fibrin deposition becomes excessive, the blood vessels may become obstructed. There is an inhibition system to guard against the cascade being inappropriately triggered, and a mechanism to remove clots once their purpose has been achieved - fibrinolysis. Normally there is a dynamic equilibrium between clotting and fibrinolysis so that the vascular system is guarded from the two principal hazards - haemorrhage and excessive clotting.

Natural Inhibitors

A number of factors act on the clot within a few minutes, limiting excessive clot formation:

  • Antithrombins reduce the level of free thrombin and absorb thrombin from fibrin strands. The most important antithrombin is antithrombin III.
  • Factors interfering with fibrin polymerisation
  • Free thrombin negative feedback - high levels of free thrombin destroys activated Factor VIII.

Increased Coagulation - haemorrhagic shock syndrome

Coagulants enhance the clotting process - the most commonly encountered coagulants are toxins such as snake venoms. Some venoms have a thrombin-like activity whereas other venoms have a plasma thromboplastin-like effect. Some snakes (Russell's viper, Malayan Pit viper) induce defibrination.

Fibrinolysis

The mechanism of fibrinolysis is designed to prevent the danger of over-production or persistence of fibrin. Plasminogen, and inactive proenzyme in plasma can be activated by a variety of factors to give plasmin, an active protease which breaks down fibrin. In normal haemostasis, small blood clots are usually remodelled or dispersed by fibrinolysis by 1-2 weeks post injury. Where clots are larger, fibrosis followed by recanalisation may occur. Occasionally, there may be enhancement of fibrin destruction through this system, e.g. in severe bacterial infections, for example haemolytic streptococci infections.

Following violent stress or injury with severe pain a general hyperfibrinolytic state is produced after widespread or profound clotting where all the circulating fibrinogen is used up. This can also occur on inactivation of endogenous plasminogen inhibitors, for example with patients given salicylates.

Other systems involved in haemostasis:

Activation of the blood coagulation cascade often activates, or is accompanied by the activation of other systems. This appears to be largely the result of activating Factor XII (the Hageman factor) which simultaneously triggers other body systems:

Kinin system

Usually this system is associated with inflammatory reactions.

  • Inactive kininogen (a 2-globulin fraction of plasma) is activated by plasmin and kallikreins which increases vascular permeability and leucocyte migration and may give rise to the pain sensation.

The Complement System

The complement system is another cascade system where inactive precursors in plasma are triggered by:

  • Bacterial enzymes
  • Antigen-antibody complexes
  • Thrombin