Difference between revisions of "Blood Sample Collection"
(Created page with "==Introduction== When collecting blood samples, fill tubes containing anticoagulant to the fill line and mix gently immediately after collection. Vacutainers can be used for lar...") |
Fiorecastro (talk | contribs) |
||
| (12 intermediate revisions by 2 users not shown) | |||
| Line 4: | Line 4: | ||
Always label your sample tubes with permanent marker immediately with the animal's details and the date and time of collection. Serum samples can be processed by allowing the blood to clot in an upright position and removing the serum from the tube prior to sending the sample for analysis to avoid haemolysis (bursting of the red blood cells into the serum) during transit. A more ideal method of serum separation is to centrifuge the sample -balance the centrifuge by adding a tube filled with the same volume of fluid in the opposite well in the centrifuge for safety. | Always label your sample tubes with permanent marker immediately with the animal's details and the date and time of collection. Serum samples can be processed by allowing the blood to clot in an upright position and removing the serum from the tube prior to sending the sample for analysis to avoid haemolysis (bursting of the red blood cells into the serum) during transit. A more ideal method of serum separation is to centrifuge the sample -balance the centrifuge by adding a tube filled with the same volume of fluid in the opposite well in the centrifuge for safety. | ||
| + | === Sample Type Required table === | ||
| + | The following table is a guide to the sample type required for some specific laboratory tests - seek guidance from your processing laboratory for confirmation of sample requirements, which can vary depending on the equipment used to analyse the sample. | ||
| − | + | Serum or heparin plasma should be separated as soon as possible after sample collection (allowing for clotting) to minimise haemolysis. Where there is a choice of serum or heparin plasma serum is always the preferred sample. The use of serum gel tubes will simplify the submission of serum samples. Refrences: [[NationWide Laboratories]] | |
{|border="2" width="800px" align="center" cellspacing="0" cellpadding="4" rules="all" style="margin:1em 1em 1em 0; border:solid 1px #AAAAAA; border-collapse:collapse;empty-cells:show" | {|border="2" width="800px" align="center" cellspacing="0" cellpadding="4" rules="all" style="margin:1em 1em 1em 0; border:solid 1px #AAAAAA; border-collapse:collapse;empty-cells:show" | ||
!bgcolor="#A7C1F2" width="180px"|Test Required | !bgcolor="#A7C1F2" width="180px"|Test Required | ||
| Line 61: | Line 63: | ||
!align="left" bgcolor="#F2F2F2"|ACTH | !align="left" bgcolor="#F2F2F2"|ACTH | ||
|bgcolor="#F2F2F2"|EDTA plasma | |bgcolor="#F2F2F2"|EDTA plasma | ||
| − | + | |} | |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |} | ||
| − | |||
| − | [[Category:Pathological Sample Collection]] | + | == References == |
| + | [[Category:Pathological Sample Collection|2]] | ||
Latest revision as of 16:13, 11 April 2022
Introduction
When collecting blood samples, fill tubes containing anticoagulant to the fill line and mix gently immediately after collection. Vacutainers can be used for large animal blood sample collection, and a needle and syringe for small animals. The jugular vein is the preferred collection site using a wide bore needle to prevent haemolysis of the blood from using excessive suction during collection. The cephalic and saphenous veins are alternative venipuncture sites. Ensure the venipuncture site is clean and swabbed, wear gloves and ensure you have adequate restraint prior to collecting a blood sample.
Always label your sample tubes with permanent marker immediately with the animal's details and the date and time of collection. Serum samples can be processed by allowing the blood to clot in an upright position and removing the serum from the tube prior to sending the sample for analysis to avoid haemolysis (bursting of the red blood cells into the serum) during transit. A more ideal method of serum separation is to centrifuge the sample -balance the centrifuge by adding a tube filled with the same volume of fluid in the opposite well in the centrifuge for safety.
Sample Type Required table
The following table is a guide to the sample type required for some specific laboratory tests - seek guidance from your processing laboratory for confirmation of sample requirements, which can vary depending on the equipment used to analyse the sample.
Serum or heparin plasma should be separated as soon as possible after sample collection (allowing for clotting) to minimise haemolysis. Where there is a choice of serum or heparin plasma serum is always the preferred sample. The use of serum gel tubes will simplify the submission of serum samples. Refrences: NationWide Laboratories
| Test Required | Sample Required | Comments |
|---|---|---|
| Haematology | EDTA | Mix gently immediately after collection |
| Biochemistry | Serum | Centrifuge after permitting sufficient clotting time (min 2 hours) |
| Fibrinogen | Citrate | Mix gently immediately after collection |
| SAA | Serum | Needs to be processed quickly as the half life is very short |
| Electrolytes | Heparin | Mix gently immediately after collection |
| Glucose | Fluoride oxalate | Can use fresh whole blood if tested immediately |
| Insulin | Serum | Fasting sample required |
| Prothrombin clotting time | Citrate | A normal sample is required for comparison |
| Progesterone | Serum | |
| Oestrone Sulphate | Serum | |
| Testosterone | Serum | Request Testosterone before Inhibin for GCTs |
| IgG | Serum | Measurement techniques vary so check sample requirements |
| ACTH | EDTA plasma |